-40%
Chiron FZ15W
$ 13200
- Description
- Size Guide
Description
Chiron FZ15WYear - 2001
Wired for 480V 50/60Hz / 29A
Control FANUC 18i-M
Condition - Used / For Parts only
Story behind this machine. This machine was run hard in a factory for maybe 8 years.
They pulled it out of production and it sat in storage for another 6 years.
When we got the machine it had 35 alarms, after a few months we got all the alarms cleared.
we got the spindle to turn on and do a few tool changes, even done a table index.
however, while the control is still in good shape, the mechanical side is pretty much shot.
Ball screws appear to be usable, linear rails are shot (pitted).
the unique basket tool changer, while very fast, is not repairable.
Chiron does not supply rebuild kits for the cylinders and they all leak air.
Machine has a cat40 / 12,000 RPM Spindle/ 2,362IPM Rapids (crazy fast).
XYZ Travels - 21" x 15.7" x 16.7"
You can buy the entire machine or make an offer for the FANUC parts.
If you want the fanuc parts you have to buy the entire lot.
You will have to pay for the parts in advance before we start removing them.
it will take about 2 weeks for us to remove and pack all the control parts.
list of fanuc parts in machine
FANUC 18i-MA - A02B-0238-B612 E007A1015
Power Supply - A06B-6087-H137 B
Spindle Module - A06B-6102-H226#H520 F
Servo Amp (3) - A06B-6096-H116
Servo Motors (3) - A06B-0165-B076#7000
Spindle Motor - A06B-0835-B926/OD41-R aT8/12000
Buyer pays actual freight, ships to usa only.
We will have to hire a local rigger to load on your truck. I can get estimate.
Buyer arranges for Flat bed truck.
no returns, sold as is.
machine weight - approx 14,700 lbs
If you use buy it now, please do not pay until we work out Freight cost